Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH, also apply to Pepperl+Fuchs AG.
Download the complete datasheet as a PDF:
|Luminous push-button module
|Slave type||Standard slave|
|Required master specification||≥ V2.0|
|Rated operating voltage||26.5 ... 31.6 V from AS-Interface|
|Rated operating current||≤ 30 mA (without sensors) / max. 180 mA|
|Number/Type||4 inputs for mechanical contacts|
|Voltage||21 ... 31 V|
|Input current||≤ 8 mA (limited internally)|
|Switching point||according to EN 61131-2 Typ 1|
|0 (unattenuated)||≤ 1.5 mA|
|1 (attenuated)||≥ 4 mA|
|Number/Type||4 electronic outputs, PNP|
|Voltage||21 ... 31 V|
|Current||≤ 100 mA per output, ≤ 140 mA total|
|Directive 2014/30/EU||EN 62026-2:2013|
|Degree of protection||EN 60529:2000|
|Data bits (function via AS-Interface)|
|Parameter bits (programmable via AS-i)||function|
|Ambient temperature||-25 ... 40 °C (-13 ... 104 °F)|
|Storage temperature||-40 ... 85 °C (-40 ... 185 °F)|
|Degree of protection||IP65 in accordance with EN 60529 (with corresponding displays and controls)|
|Connection||M12 round connector|
|Instruction leaflets||Language||File Type||File Size|
|Instruction leaflet / Beipackzettel||ALL||360 KB|
|Statements of compliance||Certificate No.||File Type||File Size|
|EU-Declaration of conformity / EU-Konformitätserklärung||DOC-2715A||163 KB|
|Russia TUV GOST-R||101-KC/542||90 KB|
The VAA-LT3-F86-V1 light sensor module creates a connection between the operating personnel and the AS-Interface master. The housing is designed in combination with suitable display and control elements in protection type IP65.
The internal AS-Interface I/O module is ideally suited to integrating customer-specific electronics, for example light sensors or LED lights. The printed circuit board is supplied entirely from the AS-Interface. The inputs and outputs are protected against short circuits and overload and the connection between the display and control elements and the AS-Interface circuit board can be plugged in with screw-on plug-in terminals. The connection to the AS-Interface is implemented by means of a V1 round plug (M12 x 1).
An overloading of the outputs is signalled to the AS-Interface master via the "Peripheral fault" function. Communication via the AS-Interface remains intact.
The luminous push-button module can be expanded to a total of 8 inputs/8 outputs by means of an additional printed circuit board module VAA-4E4A-CB1-Z/E2.
Communication monitoring is integrated. This switches the outputs to a currentless state if no communication is taking place over the AS-Interface cable.
The unique housing design of the new KE5 switch cabinet module enables distinct visibility and simplifies mounting, wiring, and maintenance inside switch cabinets and junction boxes.
Get to know our full range of AS-Interface products.