Ethernet-APL Surge Protector M-LBAS-IA1.DE
- For Ethernet-APL spur ports
- Intrinsically safe according to 2-WISE and FISCO
- Installation on DIN mounting rail in cabinet or field junction box
- Direct grounding of the cable shield
Contact Us
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
Datasheet excerpt: Technical data of M-LBAS-IA1.DE
| Product Description |
|---|
| Ethernet-APL surge protector for cabinet installation, Ex ia, Ex ec, direct shield grounding |
| General specifications | ||
|---|---|---|
| Design / Mounting | Cabinet installation | |
| Ethernet Interface | ||
| Interface type | Ethernet-APL auxiliary device | |
| Electrical specifications | ||
| Rated voltage | 30 V | |
| Rated current | 500 mA | |
| Impulse rating | 2 kV/1 kA (category C1) per line 10 kV/5 kA (category C2) per line 1 kA (category D1) per line |
|
| Impulse discharge current (10/350 µs) | 0.5 kA per line | |
| Nominal discharge current (8/20 µs) | ||
| per line | 5 kA | |
| total | 10 kA | |
| Shield | 10 kA | |
| Max. surge current (8/20 µs) | 10 kA overstressed fault mode 3 acc. to IEC 61643-21 | |
| Voltage protection level | ||
| Line/Earth | max. 1500 V C1 , 1 kA per line max. 2100 V C2 , 5 kA per line max. 50 V C3 , 50 A per line max. 1300 V B2 , 50 A per line |
|
| Standard conformity | ||
| Degree of protection | IEC/EN 60529 | |
| Climatic conditions | IEC 60721 | |
| Shock resistance | EN 60068-2-27 | |
| Vibration resistance | EN 60068-2-6 | |
| Surge protection | IEC 61643-21 | |
| Ethernet | Ethernet-APL , IEEE 802.3 for 10BASE-T1L |
|
| Ambient conditions | ||
| Ambient temperature | -40 ... 80 °C (-40 ... 176 °F) | |
| Storage temperature | -50 ... 90 °C (-58 ... 194 °F) | |
| Relative humidity | ≤ 95 % non-condensing | |
| Shock resistance | 15 g 11 ms | |
| Vibration resistance | 1 g , 10 ... 150 Hz | |
| Mechanical specifications | ||
| Connection type | screw terminals | |
| Core cross section | solid wire 0.5 ... 2.5 mm2 , stranded wire 0.5 ... 1.5 mm2 |
|
| Housing material | Polyamide PA 6.6 | |
| Degree of protection | IP20 | |
| Mass | 32 g | |
| Mounting | 35 mm DIN mounting rail | |
| Data for application in connection with hazardous areas | ||
| EU-type examination certificate | TÜV 22 ATEX 8786 X , TÜV 22 ATEX 8816 X | |
| Marking | 2-WISE auxiliary device , FISCO | |
| Marking |  ll 3 G Ex ec llC T6 Gc , ll 2 (1) G Ex ia [ia Ga] IIC T6 Gb , ll 2 (1) D Ex ia [ia Da] lIIC T80°C Db , l M2 (M1) Ex ia [ia Ma] l Mb |
|
| Voltage | 30 V | |
| Current | 500 mA | |
| Internal capacitance | negligible 0 nF | |
| Internal inductance | negligible 0 µH | |
| Directive conformity | ||
| Directive 2014/34/EU | EN 60079-0:2018 , EN 60079-11:2012 , IEC TS 60079-47:2021 |
|
| Supplementary information | ||
| International approvals | ||
| IECEx approval | IECEx TUR 22.0017X | |
| Approved for | Ex ec llC T6 Gc , Ex ia [ia Ga] IIC T6 Gb , Ex ia [ia Da] lIIC T80°C Db , Ex ia [ia Ma] l Mb |
|
| General information | ||
| Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27171202 |
| ECLASS 12.0 | 27171202 |
| ECLASS 11.0 | 27130805 |
| ECLASS 10.0.1 | 27130805 |
| ECLASS 9.0 | 27130805 |
| ECLASS 8.0 | 27130805 |
| ECLASS 5.1 | 27130801 |
| ETIM 9.0 | EC000941 |
| ETIM 8.0 | EC000941 |
| ETIM 7.0 | EC000941 |
| ETIM 6.0 | EC000941 |
| ETIM 5.0 | EC000941 |
| UNSPSC 12.1 | 39121610 |
Details: M-LBAS-IA1.DE
The surge protector protects spur ports of Ethernet-APL field switches used with Ethernet-APL field devices and PROFIBUS PA field devices.
The surge protector directs power from voltage surges and lightning to earth via gas discharge tubes.
For direct grounding of both ends of the cable shield, the surge protector connects the cable shield directly to ground.
The device is certified intrinsically safe for circuits in explosion-hazardous areas Zone 0 ... 2 according to 2‑WISE and FISCO. The surge protector can be installed in Zone 1 ... 2.
Mounting on a 35 mm DIN mounting rail permits installation in cabinets or fieldbus junction boxes.
Datasheet: M-LBAS-IA1.DE
| Datasheet | File Type | File Size |
|---|---|---|
| Datasheet M-LBAS-IA1.DE | 1160 KB | |
| Datenblatt M-LBAS-IA1.DE | 1163 KB |
Documents: M-LBAS-IA1.DE
CAD+CAE: M-LBAS-IA1.DE
| CAD | File Type | File Size |
|---|---|---|
| CAD 3-D / CAD 3-D | STP | 3749 KB |
Approvals+Certificates: M-LBAS-IA1.DE
- Ask an Expert
- Cross Reference Request
- Check order status
- News
- NetPartner Login
- Subscribe to Gate-Way, our Process Automation Division e-newsletter
- Service Level Agreements for ecom instruments
- Find a Local Distributor or Representative
- Literature
- Technologies
- Control System Solutions
- Download Technical Documents
- Press Releases
- International Trade Shows
Ethernet-APL enables continuous communication across all hierarchy levels. Learn more about the pioneering technology …
Pepperl+Fuchs Inc.
1600 Enterprise Parkway
Twinsburg, OH 44087
United States of America
sales@us.pepperl-fuchs.com
+1 330 425-3555
Pepperl+Fuchs is a leading developer and manufacturer of electronic sensors and components for the global automation market. Continuous innovation, enduring quality, and steady growth have been the foundation of our success for more than 70 years. Pepperl+Fuchs employs 6,300 people worldwide and has manufacturing facilities in Germany, USA, Singapore, Hungary, Indonesia and Vietnam, most of them ISO 9001 certified. Pepperl+Fuchs does not sell personal data.