|
|   |
| Product |
|
|
|
| Suitable for the connection of sensors and absolute encoders with SSI interface, Converts both SSI data and serial data into a parallel format, Parallel output 25 bit (Push-pull, short-circuit proof), RS 232 Interface for the serial read out of sensor information, SSI:Master or slave operation fa |
|
|
|
|
| Single-channel terminal amplifier with line breakage detection, input for NAMUR sensors, DC 24 V supply voltage, standardized interface to prevent signal transmission errors, switching state display, LED yellowfa |
|
|
|
|
Limit frequency 40 kHz, Voltage or current ouptput, Incrementing output
(Spacing factor 1 ... 9999), Multi-range power pack, 2-, 3-, 4-wire and NAMUR sensors as well as rotary encoder connectable, Rated voltage: 200 ... 230 V AC ; 100 … 130 V AC; 50 Hz
20 VDC ... 30 VDCfa |
|
|
|
|
| 1-channel terminal amplifier, NAMUR sensor input, DC 24 V supply voltage, Standard interface for prevention of signal transmission errors, Switching status indicator, yellow LEDfa |
|
|
|
|
| Relay output with 1 pole, yellow LED indicates switching state, Free-wheeling diode, Compact terminal housing, Clips onto standard 35 mm rail to DIN EN 50 022, Degree of protection IP20fa |
|
|
|
|
| Suitable for the connection of sensors and absolute encoders with SSI interface, Analog output 0/4 mA ... 20 mA, RS 232/RS 485-Interface for serial readout of sensor information, SSI:Master or slave operation , Specified option for arbitrary linearization characteristicsfa |
|
|
|
|
| 1-channel terminal amplifier, NAMUR sensor input, DC 24 V supply voltage, Standard interface for prevention of signal transmission errors, Switching status indicator, yellow LEDfa |
|
|
|
|
| 1-channel terminal amplifier, NAMUR sensor input, DC 24 V supply voltage, Standard interface for prevention of signal transmission errors, Switching status indicator, yellow LEDfa |
|
|
|
|
|
Limit frequency 40 kHz, Voltage or current ouptput, Incrementing output
(Spacing factor 1 ... 9999), 2-, 3-, 4-wire sensors and rotary encoder can be connected, Auxiliary power output for sensors, Rated voltage: 20 ... 30 V DCfa |
|
|
|
|
Limit frequency 40 kHz, Voltage or current ouptput, Incrementing output
(Spacing factor 1 ... 9999), 2-, 3-, 4-wire sensors and rotary encoder can be connected, Auxiliary power output for sensors, Rated voltage: 20 ... 30 V DCfa |
|
|
| |
Phone: 330-486-0001
Fax: 330-405-4710
Contact Us
Contact Us
