Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
Descargue la hoja de datos completa en PDF:
General specifications | ||
---|---|---|
Signal type | Digital Input | |
Supply | ||
Connection | d14+, z14- | |
Rated voltage | 20.4 ... 27.6 V DC | |
Ripple | ≤ 10 % | |
Rated current | approx. 130 mA | |
Input | ||
Input (intrinsically safe) | ||
Connection | channel 1: d2+, d4- channel 2: z2+, z4- |
|
Rated values | acc. to EN 60947-5-6 (NAMUR), see manual for electrical data | |
Open circuit voltage/short-circuit current | approx. 8 V DC / approx. 8 mA | |
Switching point/switching hysteresis | 1.2 ... 2.1 mA / approx. 0.2 mA | |
Pulse/Pause ratio | ≥ 0.5 ms / ≥ 0.5 ms | |
Input (non-intrinsically safe) | ||
Connection | start-up override: channel 1: d16, channel 2: z16 mode of operation output relay: channel 1: b16, channel 2: b18 |
|
Input current | 1 mA | |
Signal level | 1-signal: 15 ... 30 V DC 0-signal: 0 ... 5 V DC |
|
Input delay | 5 ... 20 ms | |
Output | ||
Connection | channel 1: output I: d30, d28, d32, output II: d24, d22, d26, output III: d18, output IV: d20 channel 2: output V: z30, z28, z32, output VI: z24, z22, z26, output VII: z18, output VIII: z20 |
|
Switching current | max. 10 mA , short-circuit protected (outputs III, IV, VII, VIII) | |
Output | signal ; relay (outputs I, II, V, VI) electronic output, active (outputs III, IV, VII, VIII) |
|
Signal level | 0-signal/1-signal: 19 V DC switched off (off-state current ≤ 10 µA) (outputs III, IV, VII, VIII) | |
Contact loading | 50 V AC/2 A/cos φ = 1/1 A/cos φ = 0.3; 70 V DC/100 W resistive load (outputs I, II, V, VI) | |
Energized/De-energized delay | approx. 10 ms / approx. 5 ms (outputs I, II, V, VI) | |
Mechanical life | 2 x 105 switching cycles (outputs I, II, V, VI) | |
Transfer characteristics | ||
Measurement range | 0.001 ... 99 Hz | |
Switching frequency | ≤ 1 kHz | |
Switching hysteresis | approx. 1 % of adjusted trip point | |
Switching point error | ≤ 1 % of adjusted trip point | |
Repeat accuracy | ≤ 1 % of adjusted trip point | |
Galvanic isolation | ||
Input/Output | available | |
Input/power supply | available | |
Output/power supply | available | |
Directive conformity | ||
Electromagnetic compatibility | ||
Directive 2004/108/EC | The device has been used for the same applications for several years. It therefore features an appropriate electromagnetic field immunity. The device must not be used in new plants. | |
Conformity | ||
Degree of protection | IEC 60529 | |
Ambient conditions | ||
Ambient temperature | 0 ... 60 °C (32 ... 140 °F) | |
Mechanical specifications | ||
Degree of protection | IP20 | |
Connection | 48-pin plug connector acc. to DIN 41612 , series 2 , type F , z, b and d provided | |
Mass | approx. 300 g | |
Dimensions | 20 x 128 x 193 mm (0.8 x 5 x 7.5 inch) | |
Height | 128 mm | |
Width | 20 mm | |
Length | 190 mm | |
Construction type | Eurocard 100 x 160 mm (3.9 x 6.3 inch) acc. to DIN 41494, front panel 4TE, mountable in 19 inch rack | |
Coding | a3/c3 | |
Data for application in connection with hazardous areas | ||
EU-type examination certificate | PTB 00 ATEX 2210 , for additional certificates see www.pepperl-fuchs.com | |
Marking | II (1)GD [EEx ia] IIC | |
Input | EEx ia IIC | |
Voltage | 12.7 V | |
Current | 20 mA | |
Power | 62 mW (linear characteristic) | |
Supply | ||
Maximum safe voltage | 40 V (Attention! The rated voltage can be lower.) | |
Directive conformity | ||
Directive 94/9/EC | EN 50014:1997, EN 50020:1994 | |
General information | ||
Supplementary information | EC-Type Examination Certificate, Statement of Conformity, Declaration of Conformity, Attestation of Conformity and instructions have to be observed where applicable. For information see www.pepperl-fuchs.com. |
System | Classcode |
---|---|
ECLASS 13.0 | 27210128 |
ECLASS 12.0 | 27210128 |
ECLASS 11.0 | 27210128 |
ECLASS 10.0.1 | 27210128 |
ECLASS 9.0 | 27210128 |
ECLASS 8.0 | 27210190 |
ECLASS 5.1 | 27210121 |
ETIM 9.0 | EC002918 |
ETIM 8.0 | EC002918 |
ETIM 7.0 | EC002918 |
ETIM 6.0 | EC002918 |
ETIM 5.0 | EC002475 |
UNSPSC 12.1 | 39121007 |
Manuals | Idioma | Tipo de archivo | Tamaño |
---|---|---|---|
Brief Instructions - E-system | ENG | 320 KB |