국가 선택
UDCM-30GS-3EP1-IO-0,2M-V19 Double Sheet Sensor
주요 혜택 한눈에 보기
- Ultrasonic system for reliable detection of no, one, or two overlapping sheet materials, preferably sheet metal
- Insensitive to printing, colors, and shining surfaces
- Perpendicular or inclined sensor mounting relative to the sheet plane possible
- Integrated alignment aid
- IO-Link Interface for process data, parameterization and diagnosis
- Synchronization options
- No teach-in required
더 보기
선호 제품 유형




















참고
Pepperl+Fuchs GmbH 또는 Pepperl+Fuchs AG 명의로 전환 이전에 발행된 인증서, 적합성 선언서 등 모든 제품 관련 서류는 Pepperl+Fuchs SE에도 적용됩니다.
EN
- EN
- DE
- ES
- FR
- ZH
UDCM-30GS-3EP1-IO-0,2M-V19 기술 데이터
| Sensing range | 50 ... 150 mm , optimal distance: 80 mm | |
| Transducer frequency | approx. 85 kHz |
| Non-volatile memory | EEPROM | |
| Write cycles | 300000 |
| LED green | indication: single sheet detected flashing (1 Hz) - standby mode flashing with short break (1 Hz) - IO-Link mode | |
| LED yellow | indication: no sheet detected (Air) | |
| LED red | indication: double sheet detected flashing: device error |
| Operating voltage | UB | 18 ... 30 V DC , ripple 10 %SS |
| No-load supply current | I0 | ≤ 100 mA |
| Power consumption | P0 | ≤ 1500 mW |
| Time delay before availability | tv | ≤ 300 ms |
| Interface type | IO-Link | |
| IO-Link revision | 1.1 | |
| Device profile | Identification and Diagnosis - I&D | |
| Process data | Input: 16 Bit - measurement value 8 Bit - selected threshold set 2 Bit - switching signals 3 Bit output: 8 Bit - threshold set 2 Bit - disable transducer 1 Bit | |
| Vendor ID | 1 (0x0001) | |
| Device ID | 3148292 (0x300A04) | |
| Transfer rate | COM1 (4.8 kbits/s) | |
| Min. cycle time | 22.4 ms | |
| SIO mode support | yes | |
| Compatible master port type | Class A (use adapter cable listed in accesories) Class B (use 3-pole adapter or 3-wire cable) |
| Designation | SYNC | ||||||||||||||||
| Input/output type | 1 synchronization connection, bidirectional | ||||||||||||||||
| |||||||||||||||||
| Synchronization frequency | |||||||||||||||||
| |||||||||||||||||
| Designation | IN2/FEEDBACK | ||||||||||
| Input/output type | input or output programmable via IO-Link : input for selection of a threshold set (factory default) output as feedback output | ||||||||||
| Input type | digital input | ||||||||||
| |||||||||||
| Output type | PNP | ||||||||||
| |||||||||||
| Designation | IN1/TEACH | |
| Input type | 0-level: 0 ... + 1V 1-level: +UB - 1 V ... +UB | |
| Pulse length | ≥ 100 ms | |
| Impedance | ≥ 60 kΩ |
| Designation | OUT 1 ... 3 | |
| Number | 3 | |
| Output function | OUT 1: single sheet detected OUT 2: double sheet detected OUT 3: no sheet detected (air) | |
| Output type | Push-pull (4 in 1) output ( Normally open/closed programmable ) output is LOW when event is detected: NPN = closed / PNP = open | |
| Rated operating current | Ie | 100 mA per output |
| Voltage drop | Ud | ≤ 3 V |
| Switch-on delay | ton | 30 ms (programmable) |
| Switch-off delay | toff | 30 ms (programmable) |
| Pulse extension | can be activated (100 ms or IO-Link cycle time) | |
| Fusing | reverse polarity protected , overload and short-circuit resistant |
| Standard conformity | |||||
| |||||
| UL approval | cULus Listed, General Purpose, Class 2 Power Source | |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Ambient temperature | 0 ... 60 °C (32 ... 140 °F) | |
| Storage temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Connection type | fixed cable with plug | ||||||||||||||||
| Housing length ultrasonic | |||||||||||||||||
| |||||||||||||||||
| Housing diameter ultrasonic | |||||||||||||||||
| |||||||||||||||||
| Degree of protection | IP65 | ||||||||||||||||
| Material | |||||||||||||||||
| |||||||||||||||||
| Connector | |||||||||||||||||
| |||||||||||||||||
| Cable | |||||||||||||||||
| |||||||||||||||||
| Mass | 300 g | ||||||||||||||||
| Tightening torque, fastening screws | max. 30 Nm | ||||||||||||||||
관련 페이지
더 많은 정보를 찾고 계신가요? 관련 페이지에서 자유롭게 자세히 알아보세요.